Floor Coating
ECO-CRETE 200 HD Plastering mortar
- usage
- Concrete flooring material for indoor factory floors, etc. such as food factories, cold storage warehouses, etc.
This paint is a three-component flooring material for concrete that is composed of a base, a hardener and powder by using the binding between polyurethane resin and inorganic powder. It is a non-solvent type eco-friendly product with excellent physical performance in terms of abrasion resistance, chemical resistance and impact resistance as well as excellent boiling water resistance compared to other flooring materials. Applying a single coat, 6㎜ thick coating can be formed by plastering mortar which gives excellent anti slip physical property. In particular, it can be used for concrete floors in a state where the water content is temporarily high.
specification
- Paint type
- Polyurethane resin / Powder (Three-Component)
- Drying time
-
Drying time Category 5℃ 20℃ 30℃ Set-to-touch 12 hours 6 hours 3 hours Dry-through 24 hours 12 hours 8 hours Over-coat (Min.) 24 hours 16 hours 12 hours Over-coat (Max.) 72 hours 48 hours 36 hours Pot life 20 minutes 15 minutes 10 minutes - Thinner
- DR-700, DR-700L, DR-790
- Dilution ratio
- ▷No dilution ▷In case of high viscosity in the winter season, dilute within the volume ratio 1%
- Specific gravity
- 2.0 (Based on green color)
- Theoretical Coverage
- 12 ㎏/㎡
- Solid volume ratio
- 95±3 % (Based on green color)
- Color
- Green, gray, reddish brown, iron yellow
- Thickness of dried film
- 6 ㎜
- Mixing ratio
- Base/Hardener/Powder =3.4/3.6/32(Weight ratio)
- Gloss
- Matte
- Shelf life
- 6 months
- Packaging unit
- Base(3.4 ㎏), Hardener(3.6㎏), Powder(32.0㎏)
- Flash point
- 110℃
PRODUCT PROPERTIES (PHYSICAL PROPERTY DATA)
- Compressive strength
- More than 40 N/㎟
- Adhesion strength
- More than 1.5 N/㎟
- Bending strength
- More than 15 N/㎟
- Hardness
- More than shore D 60
how to use
- Surface treatment
- 1. Cure concrete for at least 28 days at a temperature of 21℃ and a relative humidity of 50%. (PH 7~9)
2. Completely remove the oil, moisture, sand, dust, laitance and other foreign matter from the surface and maintain surface smoothness.
3. Please repair severe bumps or cracks with a paste of intermediate coating material. - Coating method
- 1. Apply smoothly using sawtooth scraper, rubber scraper, pitchfork, square towel, etc.
2. Remove air bubbles inside the coating by using a spike roller simultaneously with painting.
Appropriate construction specifications
▷Primary coating: To prevent air bubbles, primary coating is done by applying a thickness of about 1㎜~2㎜.
▷Secondary coating: Apply uniformly with trowel by plastering mortar.
(If necessary, make the surface flat with a roller right after application) - Coating conditions
- 1. Atmosphere Temperature: 5~35℃, Surface Temperature: 40℃ or below, Relative Humidity: 80% or less
2. Moisture content in the concrete: 6% or less